Verify all cooling fans are operational while the system is powered on. Monthly PM Checklist
systems, this allows for rapid cycle creation using intuitive 3D displays. ZHM (Out of Mould Area) sepro robot user manual hot
Which (X, Y, Z, or rotation) is triggering the "hot" condition? Verify all cooling fans are operational while the
Emily laughed, realizing she had been so entranced by the robot's sizzling performance that she had forgotten about the manual's warnings. She quickly deactivated Turbo Mode, and the SEPRO robot returned to its standard, more sedate behavior. Emily laughed, realizing she had been so entranced
The servo drives located inside the main electrical cabinet are overheating. This is often caused by a failure to dissipate the heat generated by constant braking and acceleration.
If your Sepro robot utilizes identical servo drives for multiple axes (e.g., X and Y use the same drive model), you can temporarily swap the drives to isolate the problem. If the error stays with the physical drive module, the drive's internal sensor or transistor is failing. If the error stays with the axis, the motor or cable harness is defective. Contacting Sepro Service