Motorola Cp140 Programming Software Link [UPDATED]

Configure CTCSS/PL or DCS codes to minimize interference from other users.

This is the link printed in Motorola’s own December 2003 installation manual for the CP140/CP160/CP180.

Do not bump the cable, turn off the radio, or close the software during this process. motorola cp140 programming software link

In the CPS preferences, set the communication port to match the COM port from Device Manager.

If using a USB programming cable, you must install the correct Virtual COM Port (VCP) drivers (typically FTDI or Prolific drivers) so your computer can recognize the cable as a communication port (e.g., COM3). 4. Step-by-Step CP140 Programming Guide Configure CTCSS/PL or DCS codes to minimize interference

The is programmed using the Commercial Series Customer Programming Software (CPS) . While Motorola requires a business account to download software directly from their official support portal , there are accessible ways to obtain and use it. Where to Get the Software

The Commercial Series CPS went through several revisions. Important versions to be aware of include: In the CPS preferences, set the communication port

If you have two identical CP140 radios, you can clone one from the other without using a PC. Connect a between the two radios, turn on the destination radio first, then press and hold the two side buttons on the source radio. The entire configuration is duplicated in seconds.